This course consists of ON-HAND experience with Arduino UNO board. One will learn to interface various hardware using Arduino IDE. You can do ROBOTICS by yourself after this course.

Course Duration: 4 Weeks (4 days a week with 1.5 Hours a day (OR) 3 days a week with 2 Hours a day (OR) Weekend - Saturday & Sunday with 3 Hours a day).

Prerequisite: Must have completed the First or Third micro controller course.  

Outline:

• Basic features of Arduino UNO Board

• Read ATMEGA328 datasheet

• Arduino IDE Configuration for Arduino UNO.

• Introduction to various interfacing hardware.

• Programming UNO interfacing hardware and uploading using Arduino IDE

They will learn the following:

1. Basics of each hardware as below: (First  8 and any FOUR from the rest)

INTERFACE-HARDWARE:

1. Transistor

2. Mosfet

3. Relay - Can Control 230 VAC with this.

4. Light Sensor - LDR

5. Heat Sensor - Thermistor

6. Sound Sensor - MIC

7. LED Matrix

8. Switch Matrix

9. RGB LED (Pixel-Data line)

10. Motor

11. 7 Segment Display

12. SERVO Motor - (Robotics)

13. STEPPER MOTOR (Robotics)

14. IR Module (Robotics)

15. Hall Effect Sensor

16. PIR sensor (Robotics)

17. Ultrasonic Sensor (Robotics)
18.  Rotary encoder (Robotics)

19. 4 Digit Seven Segment Display (Clock, Temperature etc)

20. Real Time Clock (Battery Backed)

21. Vibration sensor (Robotics)

22. Tilt Sensor (Robotics)

23. MicroSD Card Reader & Writer Module and MORE ....

2. Basic Codes to interface with these hardware

3. These hardware covers all core engineering project requirement.

4. Support for further application during the course.

Student Contribution:

1. Breadboard, Single stud wires, Micro USB data cable of mobile, Laptop.

2. Plain Note book

3. Box to place all the components.

You will be given:

1. All hardware(First 8 + Any 4 from remaining) with required Resistors, Two types of LEDs, Variable Resistors, Capacitors, Button switch etc.

2. Required reading materials

Certificate: Daily progress will be monitored and successful completion is required. Oral Questioning session for 5 min.s and Practical Test. 

Course Fees : Introductory fees Rs. 7,600/- (Rs.8,999/-)

Bread Board:840 Pins board 1 or 2Nos