This course consists of ON-HAND experience with ATMEL Micro-controller basics & interfacing with hardware. One will learn to interface various hardware using Arduino IDE. You can do ROBOTICS by yourself after this course.

Course Duration: 6 Weeks (4 days a week with 1.5 Hours a day (OR) 3 days a week with 2 Hours a day (OR) Weekend - Saturday & Sunday with 3 Hours a day).

Prerequisite:  Age: 12 years [7th Passed]. Must have completed the course "Fundamentals of Electrical and Electronics"  (OR)

Had passed 12th standard / Studying B.E / B.Sc. etc.,

Outline:

• Basics of Micro controller 

  • To read any datasheet

  • Arduino IDE Installation, Configuration

  • Arduino IDE Programming Structure

  • Programming and uploading using Arduino IDE

• Introduction to various interfacing hardware.

• Programming UNO interfacing hardware and uploading using Arduino IDE

They will learn the following:

1. Basics of each hardware as below: (First 7 and any ONE from remaining)

INTERFACE/HARDWARE:

1. Transistor

2. Mosfet

3. Relay - Can Control 230 VAC with this.

4. Light Sensor - LDR

5. Heat Sensor - Thermistor

6. Sound Sensor - MIC

7. LED Matrix

8. Switch Matrix

9. RGB LED (Pixel-Data line)

10. Motor

11. 7 Segment Display

12. SERVO Motor - (Robotics)

13. PIR Module (Robotics)

14. IR Module (Robotics)

15. Hall Effect Sensor

16. Ultrasonic Sensor (Robotics)

17.Vibration sensor (Robotics)

18. Tilt Sensor (Robotics)

19. 4 Digit Seven Segment Display (Clock, 

        Temperature etc)

2. Basic Codes to interface with these hardware

3. These hardware covers all core engineering project requirement.

4. Support for further application during the course.

Student Contribution:

1. Breadboard : Around Tie-840 Points board 1 or 2Nos.

2. Single stud wires, Micro USB data cable of mobile, Laptop.

3. Plain Note book

4. Box to place all the components.

You will be given:

1. ATMEL 8 Pin Micro-controller with PCB soldered with berg stick.

2. All hardware (First 7 + Any ONE from the remaining) with required Resistors, Two types of LEDs, Variable Resistors, Capacitors, Button switch etc.

3. Required reading materials

Certificate: Daily progress will be monitored and successful completion is required. Oral Questioning session for 5 min.s and Practical Test. 

Course Fees : Introductory fees Rs. 7,600/- (Rs.8999/-)